First Time Use & Tips

1. Selector switch 1 (0) - Controls the electricity supply to the appliance and flame effect. Press for ‘ON' & ‘Standby’. If both selector switches 2 and 3 are in the OFF position, the product works on flame effect only.

2. Selector Switch 2 (I) - Provides 750W heat output.

3. Selector Switch 3 (II) - Provides 1.5kW output with switch 2 also pressed.

The switches provide a choice of heat settings. The appliance is in standby mode when the mains lead is plugged in. This is indicated by the red neon behind the flame effect screen. The two selector switches are in the ON position when the side with the markings on (i.e. I, or II) are pushed in.

In order to maintain a certain room temperature, set the controller to ‘max’. Operate the appliance at full power until the required room temperature is reached. Set back the thermostatic controller until the appliance switches off with an audible “click”. This temperature will be kept almost constant by the thermostatic control switching on and off automatically. Please note that the appliance can only be switched on when the thermostat setting is higher than the room temperature.

Over time, dust can accumulate which can effect performance. It is recommended to clean the unit at least once a month. CAUTION: ALWAYS Turn the unit OFF and disconnect the appliance from the power supply before undergoing any cleaning and maintenance. For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners. To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater.

1. To activate the remote control, remove the battery isolation strip, which is used to ensure your remote control reaches you fully charged.

2. To replace the remote control battery, turn over the remote control, and follow the diagram embossed on the remote control.

1. Remove the screw, push down on the battery cover located on the back of the remote control. Slide the battery cover open.

2. Install 1 x 3V CR2025 or CR2032 Lithium battery in the battery holder. The positive (+) side of the battery faces up.

3. Close the battery cover and replace the screw.