First Time Use & Tips

See below:

1. Press the POWER button to turn the unit On or Off. After it is switched on, the dehumidifying function will start immediately. The power indicator light next to 'DEH' will light up. When the compressor stops, the light will flash.

2. Press the SPEED button to switch the fan speed. The fan speed can be switched between high and low. Please note that in the COMFORT setting ('AU'), when the room temperature is above 27°C, the fan speed is fixed on high.

3. Press the UP and DOWN buttons to set your required humidity, between 30-90%. The CONTINUOUS ('CO') setting will be the default. After 90%, you can also select the COMFORT ('AU') setting. The CONTINUOUS and COMFORT settings are further explained in the functions section of the manual. Press these buttons at the same time to change the display between the room temperature and the humidity. The indicator light for C° will switch on when showing the temperature, and the % indicator light will switch on when showing the humidity levels.

4. Press the TIMER button to set the timer on the unit. When the device is On, press this button to set the timer for scheduled shut down. When the device is Off, press this button to set the timer for a scheduled switch on. The timer ranges between 1-24 hours and increases in increments of 1 hour with each click. When the timer is set to turn on the device, the timing on the device will display. When the timer is set to turn off the device, the humidity will display after 5 seconds.

5. Press the MODE button to set your desired mode. There are three modes, being DEHUMIDIFY (DEH), FAN and DRY (Laundry).

6. Press the WIFI button for 5 seconds to connect the device to Wi-Fi. The indicator light will switch and stay on if it successfully connects. The Glen Dimplex Connect phone app will allow for device functions to be controlled through the app as well. Please follow the included Wi-Fi instructions/app prompts to work this.

7. Press the LOCK key for 5 seconds to enable the CHILD LOCK function. In this setting, all buttons except the LOCK button cannot be operated. Press this button again to turn Off.

1. Place the dehumidifier on a level surface.

2. Unscrew the cap on the back of the unit to access the hose nozzle. * Please note, the water tube is not supplied with the unit.

3. Thread a garden hose onto the accessible nozzle, lead to a floor drain and cut to length. Make sure there are no kinks or knots in the garden hose. * Please note, the water tube is not supplied with the unit.

4. Turn the unit ON and press the MODE button and select CONTINUOUS.

1. When the filter needs cleaning, the “Clean Filter” indicator will light on (after 250 hours of use).

2. Remove the filter from the back of the unit by using your thumbs to press down on the filter tabs.

3. Tap excess dust off the filter.

4. Clean the filter with warm soapy water.

5. Allow to dry naturally and thoroughly before replacing the filter. Do not expose the filter to sunlight.

6. Replace the filter and press the FILTER button.